PROFINET KUNBUS-IC
Compact DIL-32 module for PROFINET networks

Specifications
- DIL32 module 25 x 45mm
- Power supply 3.3V
- Low power consumption
- SDI Modbus interface to the application
- RS485, RS232, UART
- Protocolscripter
- Terminal/Modbus RTU permits individual configuration
- Same pin-out to the application
- 1,5kV galvanic separation of application and bus
- Service interface: CDI (config, debug, status)
- SSC shift register recognition (SPI)
- Automatic Baud rate recognition
- Automatic shift register recognition
- Modules are PNO-certified and 100 % tested
- 5V version upon request
Environmental Conditions
- Operating temperature: 0°C to +60°C
- Storage temperature: -30°C to +85°C
- Humidity: 0% to 95%, non-condensing
- Condensing: not allowed
- Mechanical shock load: 15G
- Permanent mechanical stress: 5G
Article | Article No. |
---|---|
KUNBUS-IC PROFINET IRT Slave / 3.3 V | 100048 |
Downloads |
---|
KUNBUS-IC Flyer |
KUNBUS-IC PROFINET User Manual |
KUNBUS-IC PROFINET XML File |
KUNBUS-IC PROFINET Certificate |
other PROFINET modules | Article No. |
---|---|
Customized PROFINET Module | -- |
Minimize development efforts and save time and money with the product introduction of PROFINET RT into your device - KUNBUS-IC offers a simple option to integrate ProfiNet RT (PROFINET slave device) into your device with maximum efficiency.
Our KUNBUS-IC modules not only have the required PROFINET RT interface, but also an interface to your control. A standard pin-out permits realization of all of our buses by simple replacement of the module type. The KUNBUS-IC modules naturally have all the necessary components like optoelectronic coupler, bus driver, and microcontroller, bus components, and the indispensable memory. Furthermore, KUNBUS-IC modules have proven themselves in the security field, have been tested 100 %, and naturally are PNO-certified.
Connection of the KUNBUS-IC module to the processor of your control for implementation of PROFINET KUNBUS-IC RT (PROFINET KUNBUS-IC IRT as COM module) can be realized with a UART interface. A shift register interface can be used for devices without a processor. The signal distribution (32x8 bytes) to the input and output registers is done as required. This permits, for example, a split into 5x input and 27x output. Via a second serial CDI interface, a terminal can be connected, for example, as a debugging and configuration interface. A galvanic separation of up to 1.5 kV between the bus interface and control has also been realized on the module. Because the KUNBUS-IC PROFINET module can be operated independent of the control, the load of the processor of the control is fully reduced.